Brain Blow Level 27

Overview

A card reader sits at the top of the board, and a wallet below it holds an ID card. The prompt asks you to run the ID card. The reader will not scan anything until a card is brought to its slot, and the card is tucked inside the open wallet. The solution is to drag the ID card out of the wallet and up into the card reader. This is a single drag, and no PIN or number needs to be entered.

• Difficulty: Easy
• Estimated moves: 1

Step-by-Step Solution

1. Look at the reader at the top and the open wallet below it, and identify the ID card resting inside the wallet. The reader slot is empty at the start, so there is nothing to scan yet.

1. Press and hold the ID card in the wallet to pick it up, lifting it out of the card slot the wallet provides.

1. Drag the card upward toward the reader at the top of the board, keeping it aligned with the reader's opening so it drops into the slot.

1. Release the card once it reaches the reader, and wait for the completion feedback. The level finishes when the card is read, and the wallet left open below does not need to be closed.

1. As you lift the card out of the wallet, keep it level so it slides into the reader rather than turning sideways. The reader should register the card once its edge enters the slot, and the wallet can stay open below without being closed. If the card refuses to read, check that you are dragging the ID card itself and not the wallet flap, since the empty holder will not scan in the reader.

1. When the card enters the reader, wait for the level's completion feedback before assuming the scan failed. The reader recognizes the inserted ID automatically, and no extra tap on the reader or wallet is needed once the card has been brought to the slot.

Strategy & Reasoning

This level mirrors the real action of swiping or inserting an ID: the card has to travel from its holder to the reader before any reading can happen. The wallet and reader are two stations in the same flow, and moving the card between them is the whole task. There are no hidden numbers to decode on the card itself.

The prompt word run refers to scanning the card, not running a character across the screen, which rules out moving the wallet or tapping the reader repeatedly. Dragging the card is the direct interpretation, and once it enters the reader the system completes the action automatically. The empty reader slot at the start confirms that a card has not yet been inserted.

Tips & Common Mistakes

• Do not tap the reader expecting it to scan by itself; it needs the card brought to the slot first.
• Drag the card out of the wallet rather than moving the whole wallet up to the reader.
• Align the card with the reader opening before releasing, since dropping it beside the reader will not register.